##skip_main ##skip_menu ##skip_search
Mirka Customer Support
Your cart is empty
Add the chosen goods to your cart. Are you wondering where to begin?
Take a look at bestsellers our visit our help room.
Piston seal for Kral Arms N-01 air rifle.
Product detail page
> 100 pcs in stock,
Estimated Delivery:
May 20 - 22.
€ 2.4
2× rated
Please log in to your account if you want to rate this product. You will be able to write your review then.
By submitting your review, you are agreeing to our review guidelines. It will be published once we make sure it corresponds with our terms and conditions.
Lamač
18.08.2025
Machine translation
The old gasket in the photos.
By roughly this procedure I replaced the Kral N01
0. Check discharged
1. Unscrew the screw behind the trigger and the two screws hidden under the
rubber fish on the forearm
2. There is a pin hidden under the plastic boot at the end of the cylinder
housing, knock it out. Pull some wire through the hole to keep it from
flying out.
3. Use a ten wrench to loosen the screw holding the spring plug and the trigger
assembly
4. Pull out the spring with the mandrel and the metal weight on the face
5. Release the trigger assembly, pull it backwards. He's gonna want to play
with it a little bit. I had to pull the trigger by hand from the side.
6. Load lever out through the extension to the outside, drops the plastic wheel
and horseshoe off of it.
7. Pull the piston out, knock the old gasket off. Push the new one against the
floor or table.
I cleaned the cylinder from the inside by cleaning it on 12GA, wiped it dry
with rags. The soot buildup from the burnt vaseline wasn't as bad as
I expected.
Feels stronger after replacement, some of the bumps go through the 25mm slat.
Go to the store page of the Piston seal Kral Arms N-01
Secure shopping and payment fast delivery to many EU countries 
Excellent customer support from specialists – for over 15 years 
-20% on selected product in the loyalty program 
New videos and reviews every day 6000+ reviews from our customers 
